![]() I removed printhead as described elsewhere and carefullyįlushed with hot tap water until no further ink waste was present. My Canon MX860 locked up with the B200 error when I continued printing.Before print carriage reaches left hand side (but after going halfway across) shut the cover.Wait for print carriage to start moving to the left and let it go past half way.Clean the plastic head primers/cleaners themselves on the printer (the far right).Left the print head in the middle of the printer all while the printer was off.Lift up the grey bar by where the ink goes.When the printhead still moving and is going to the very.While the printer still open, plug the power and.Wait for print carriage to start moving to the left.īefore print carriage reaches left hand side shut the cover. Check Cable connection especially the carriage FFC.Check and Clean Head contact pin condition of the carriage unit. ![]() Disconnect the power cable from the printer.Error B200 means the printhead voltage or temperature is not normal.
0 Comments
Leave a Reply. |